Experienced supplier of High temperature resistant Minipleat filter

High temperature resistant Minipleat filter

Normally most of the filter factories can make high temperature resistant deep pleated filters with aluminum separator.

(as followed picture)

But there are only very few ones who can make high temperature resistant mini pleated filters. Cause special device is necessary. Thenow will be one of them who can make this.

Usually as for such high temperature minipleat filters, the most common is 250℃ continuous working temperature peak. Common glass fiber is available for this temperature. While if the working temperature reach up to 350℃, it has to high temperature resistant type glass fiber. And it also differs when it comes to the seal and gasket. Please refer to the following table.

Operating Temperature Peak(℃）	Efficiency	Glassfiber	Seal	Gasket
250	Medium(F6-F9)	common type	Glassfiber media	Silicon rubber or glassfiber belt
250	HEPA(E10-H14)	common type	Red silicon glue	Silicon rubber
350	Medium(F6-F9)	High temperature resistant glassfiber	High temperature resistant glassfiber	PTFE belt
350	HEPA(E10-H14)	High temperature resistant glassfiber	Ceramic glue	PTFE belt
400	Medium(F6-F9)	High temperature resistant glassfiber	High temperature resistant glassfiber	High temperature resistant glassfiber belt
400	HEPA(E10-H14)	High temperature resistant glassfiber	Ceramic glue	High temperature resistant glassfiber belt

Welcome to contact us with your special request~

Deep pleat HEPA filter without aluminum separator

Initial pressure drop VS Final Pressure drop (for a filter)

News

News